Telex ®Op er ating In struc tionsAir man ANR™ 500 Head set
CUSTOMER SERVICEFor information or technical assistance, call or write to Telex at:Customer Service DepartmentTelex Communications, Inc.12000 Portland
TELEX COMMUNICATIONS, INC. 12000 Portland Ave. S., Burnsville, MN 55337 U.S.A.l®38109-822 Rev C
Note: See page 7 for avail able re place ment parts.1Flexible BoomPermits PreciseMic PlacementNoise CancelingElectret MicrophoneReplaceableEar Cushion
Gen eral De scrip tionThe Telex Airman ANR™500 Active Noise Reduction headset combines designfeatures of a lightweight headset with the advanced techn
HEADSET OPERATION1. Connect the headset as shown in Figure 2.2. Rotate the entire boom to wear the microphone on either the right or left sideof the h
Microphone Gain AdjustmentThe microphone gain has been factory-adjusted to the nominal level requiredfor normal radio operation and should normally no
BATTERY MODULE BATTERY INSTALLATIONThe battery module requires one 9 volt battery. Alkaline batteries arerecommended for best performance. Do not us
SpecificationsReceivers:Type: DynamicFrequency Response: ±6dB re 1000 Hz over the range 350 - 3000 HzSensitivity: 90 ±5 dB SPL (1 kHz, 1 mW input per
Gen eral:Cord age:Straight cord from head set to bat tery mod ule, 5.5 ft (66")Ra dio Con nec tions: Re ceiver; 1/4" di am e ter ste reo p
8LIMITED WARRANTY — VALID ONLY IN UNITED STATES AND CANADATELEX Communications, Inc. (“Telex”) warrants to the user, who originally purchased the prod
Kommentare zu diesen Handbüchern